Spa Covers We offer three diffe

Spa Covers

We offer three different custom spa cover options. The Classic is a standard fully-insulated spa cover. The Prestige is the upgraded version of the Classic including aluminum channeling and support. Our Walk-On cover provides the ultimate in durability and safety. The Walk-On cover is made the support the weight of animals, children, and even adults. It is reinforced with fiberglass for ultimate durability. All of our covers are available in 14 different colors and just about any shape and size. For instructions on how to measure for your spa cover please scroll to the bottom of this page for our guide on measuring for your new cover.

Colors may vary due to computer monitor settings.

How to Measure for a Spa Cover

It is best if you measure your existing cover and not your spa. In order to get the proper length and width, measure across the seam, then perpendicular to that.

If you do not have a cover to measure from, then you must measure all the outside dimensions of the spa. The cover has a 2" flap around the edges of the spa called a skirt. The skirt must easily sit over the edges of the spa, with a little room to spare.

It is always better to make the cover size a little bit bigger than your spa when measuring. If you make a mistake, and measure too small, the cover will not fit properly, will not sit flat and will not hold the heat in.

All Prestige Covers come with Tie Downs and locks that can either be attached to the wood spa cabinet or be screwed to a deck.

Spas come in a variety of "standard" shapes. Determining your units shape will help
you order the proper cover.

Determine your style and measure per drawing below.

Square = L x W
Rectangle = L x W
Square with cut corners = L x W x Cut Corner Dimension
Rectangle with cut corners = L x W x Radius Dimension
Square with rounded corners = L x W x Radius Dimensions
Rectangle with rounded corners = L x W x Radius Dimension
Square with one cut corner = L x W Cut Corner Dimension
Square with two cut corners = L x W x Cut Corner Dimension
Ellipse or taper = Must supply a template and/or specific make,
year and model of spa
True Octagon = L x W x Dimension of one side
Off-set Octagon = L x W x Dimension of each side (8 total)
Six Sided = L x W x Dimension of each side (6 total)
Round = Diameter

Measuring for radius corners:

	Method #1 for determining corner radius: To determine the radius of your cover's corners, take a sheet of paper and trace around one of the curved corners of the cover. You will get a curved line similar to those shown at the left. Remove the paper and complete the circle. You can do this freehand. Then measure across the middle of the circle you drew, and divide by 2.
	Method #2 for determining corner radius: Another way to measure the radius is by placing a carpenter's square on the outside of your spa. The distance between the corner of the carpenter's square and the {a}place where it touches the spa (A) equals the radius of the curve (B).